Hombre XS Regular Cab 2WD L4-2.2L CPC (1998)
Steering Wheel: Service and Repair
Handling Electrostatic Discharge
Many solid state electrical components can be damaged by Electrostatic Discharge (ESD). Some will display a label, but many will not. In order to avoid
possibly damaging any components, observe the following:
1. Body movement produces an electrostatic charge. To discharge personal static electricity, touch a ground point (metal) on the vehicle. This should
be done any time you:
-
Slide across the vehicle seat.
-
Sit down or get up.
-
Do any walking.
2. Do not touch exposed electrical terminals on components with your fingers or any tools. Remember, the connector that you are checking might be
tied into a circuit that could be damaged by electrostatic discharge.
3. When using a screwdriver or similar tool to disconnect a connector, never let the tool come in contact with or between the exposed terminals.
4. Never use a jumper wire, ground, or use test equipment probes on any components or connectors unless specified in diagnosis. When using test
equipment, always connect the ground lead first.
5. Do not remove the solid state component from its protective packaging until you are ready to install the part.
6. Always touch the solid state components package to a ground before opening. Solid state components can also be damaged if:
-
They are bumped or dropped.
-
They are laid on any metal work benches or near components that operate electrically, such as a television, radio, or oscilloscope.