Hombre XS Space Cab L4-2.2L CPC (1997)
NOTE: Brake fluid will damage electrical connections and painted surfaces. Use shop cloths, suitable containers, and fender covers to
prevent brake fluid from, contacting these areas. Always re-seal and wipe off brake fluid containers to prevent spills.
Tools Required:
^
J 29567 Brake Bleeder Adapter
^
J 39177 Combination Valve Pressure Bleeding Tool
^
J 28434 Wheel Cylinder Bleeder Wrench
1. Fill the pressure tank at least 2/3 full of brake fluid.
^
The bleeder must be bled each time fluid is added.
2. Charge the bleeder to 140-170 kPa (20-25 psi).
Combination Valve Pressure Bleeding Tool
3. Use J 39177 to depress and hold the valve stem on the combination valve.
4. Install the bleeder adapter.
5. If the BPMV is replaced or suspected to have air trapped inside, it must be bled next.
6. Bleed each wheel in the following sequence:
A. Right rear
B. Left rear
C. Right front
D. Left front
7. Connect the hose from the bleeder to the adapter at the master cylinder.
8. Open the tank valve.
9. Attach J 28434 to a bleeder valve.
10. Immerse the opposite end of the hose into a container partially filled with clean brake fluid.
11. Slowly open bleeder valve at least 3/4 of a turn and allow the fluid to flow until no air is seen in the fluid.
12. Tighten the bleeder valve to 7 Nm (62 inch lbs.).
