Hombre XS Space Cab L4-2.2L CPC (1997)
large end. This "bump" should face away from the arrow on the piston crown.
NOTE
It is necessary to use tool J 24086-C or a fixture that does not put pressure against the piston. All press loads must be supported by the connecting rod
. Any load on the piston or piston skirt will distort the piston.
6.
Inspect the piston rod bearings for wear using service procedures outlined in the Workshop Manual. If necessary, replace with the correct size as
indicated by the measurements taken. Three sizes are available from AIPDN.
7.
Scrub the cylinder bore and replacement pistons with soapy water to remove any foreign material. Thoroughly dry the parts, install new piston
rings (Figure 1), and coat the cylinder bore, piston skirt, and piston rings, with engine oil.
8.
Install all four (4) pistons or piston and rod assemblies using the service procedures outlined in the Workshop Manual.
IMPORTANT
All four pistons must be replaced.
PARTS INFORMATION
WARRANTY CLAIM INFORMATION
