Hombre XS Space Cab L4-2.2L CPC (1997)
Live (undeployed) Supplemental Restraint Steering Wheel Inflator Module
13. Clear a space on the ground about 1.85 m (6 ft) in diameter where you intend to deploy the inflator module. If possible, use a paved, outdoor
location free of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
14. Make sure that no loose or flammable objects are within the deployment area.
Live (undeployed) Supplemental Restraint Steering Wheel Inflator Module
15. Place the inflator module in the space cleared, with its vinyl trim cover facing up.
16. Extend the SRS deployment harness and the pigtail adapter to full length from the inflator module.
17. Place a power source near the shorted end of the SRS deployment harness. Use a vehicle battery when available, but always use a power source
that complies to the following:
^
12 volts minimum
^
2 amps minimum
Important: Firmly seat the pigtail adapter into the inflator module connector. Failure to fully seat the connectors may result in non-deployment of
the inflator module.
Live (undeployed) Supplemental Restraint Steering Wheel Inflator Module
18. Connect the inflator module to the pigtail adapter on the SRS deployment harness.
^
The deployment harness shall remain shorted until you are ready to deploy the air bag.
^
Do not connect the inflator module to a power source until you are ready to deploy the air bag.
^
The inflator module will immediately deploy when you connect the power source.
19. Clear the area of all people, and any loose or flammable objects.
20. Make sure that you place the inflator module with its vinyl trim cover facing up.
