Hombre XS Space Cab L4-2.2L CPC (1997)
Second Repair
1. Remove the improperly installed rivet.
2. Enlarge the mounting holes in the lower radiator support to 9.0 mm (0.35 in).
3. Insert and properly seat rivnut. Install sensor with screw.
4. Tighten
Tighten the sensor screws to 8.0 N.m (71 lb in). Refer to Fastener Notice in General Information.
INSTALLATION PROCEDURE
CAUTION: Be careful when you handle a sensor Do not strike or Jolt a sensor. Before applying power to a sensor:
^
Remove any dirt, grease, etc. from the mounting surface.
^
Position the sensor horizontally on the mounting surface.
^
Point the arrow on the sensor toward the front of the vehicle.
^
Tighten all of the sensor fasteners and sensor bracket fasteners to the specified torque value
Failure to follow the correct procedure could cause air bag deployment, personal Injury, or unnecessary SIR system repairs.
1. Install sensor to vehicle. Arrow must point toward the front of the vehicle.
2. Install rivets.
