isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Battery Cable|Page 4003 > < Battery Cable|Locations
Page 1
background image

Battery Cable: Service and Repair
Battery Cable

Connection Locations

Some positive and negative cables have additional leads attached.

NOTE:  When connecting the positive battery cable to the starter solenoid, the inner nut on the solenoid battery terminal must be tightened. Failure to do
so, before the battery cable or any other leads are installed, will result in solenoid or terminal damage. This could also cause a slow crank condition.

-

Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.

-

Always route the replacement cable the same way as the original cable.

-

Disconnect the negative battery cable from the battery before proceeding with any replacement or repair.

-

Positive battery cable routing to the generator (2.2L)

-

Negative battery cable routing to engine block ground (2.2L)

Battery Cable|Page 4003 > < Battery Cable|Locations