Hombre XS Space Cab L4-2.2L CPC (1997)
Front Steering Knuckle: Service and Repair
Removal
NOTE:
^
The Special Service Tools (SSTs) required for this job are a J 6627-a wheel stud and tie rod remover or a J 24319-B steering linkage remover,
a J 23742 ball joint separator and a J 29193 steering linkage installer.
^
Raise the front of the vehicle and place safety stands under the front lift points. Do not place the floor stands under the lower control arms
because spring tension is needed to assist in breaking loose the ball joint studs.
1. Remove the tire and wheel assembly.
2. Detach the brake caliper taking care to suitably support the caliper to prevent damage to the brake hose.
3. Take off the brake rotor.
4. Remove the three bolts attaching the splash shield to the knuckle.
5. Loosen the remove the nut.
6. Remove the tie rod end from the knuckle using either the J 6627-A or J 24319-B tool.
7. Take off the knuckle gasket if the knuckle is to be replaced being careful not to damage the knuckle gasket.
