isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

A/T - Rusty fluid level indicator/oil filler tube|Page 3195 > < A/T - Rusty fluid level indicator/oil filler tube|Page 3189
Page 1
background image

Automatic Transmission Dipstick - Dipstick Tube: All Technical Service Bulletins
A/T - Rusty fluid level indicator/oil filler tube

BULLETIN NUMBER:
SB00-05-S001

GROUP:
TRANSMISSION

ISSUE DATE:
FEBRUARY 2000

RUSTY TRANSMISSION FLUID LEVEL INDICATOR/TRANSMISSION OIL FILLER TUBE

AFFECTED VEHICLES

1997-98 Hombre with 4L60-E A/T (M3O)

SERVICE INFORMATION

Condition:

Some owners may comment about rust on the transmission fluid level indicator and the transmission oil filler tube.

Possible Cause:

The condition may be caused from water entering through the indicator grommet.

Correction:

A new indicator, with an improved grommet and corrosion resistant metal, has been developed to correct the condition.

SERVICE PROCEDURE

Use the following procedure and the appropriate part numbers listed below.

1.

Inspect the Transmission Fluid Level Indicator for signs of excessive rust. If there are no signs of rust replace the fluid level indicator with the
revised indicator. If there are signs of rust, then proceed to step 2.

2.

Inspect the transmission fluid filler tube for signs of excessive rust on the inside or outside of the tube. Replace the tube as necessary. Refer to the
appropriate Work- shop Manual for Filler Tube Replacement procedures for Automatic Transmission 4L60E.

3.

Replace the transmission filter, Change the transmission fluid.

PARTS INFORMATION

WARRANTY CLAIM INFORMATION

Use the following Published labor operation:

A/T - Rusty fluid level indicator/oil filler tube|Page 3195 > < A/T - Rusty fluid level indicator/oil filler tube|Page 3189