Hombre XS Space Cab L4-2.2L CPC (1997)
-
Place the universal joint so that the lower ear of the yoke is supported on a 1 1/8 inch (30 mm) socket.
-
Place J 9522-3 on the open horizontal bearing cups and press the lower bearing cup out of the yoke ear. If the bearing cup is not completely
removed, lift the cross and insert tool J 9522-5 between the seal and bearing cup being removed and continue to press it out of the yoke.
-
Rotate the propeller shaft and press the opposite bearing cup out of the yoke.
Disassemble
1. The cross from the yoke.
2. Remaining universal joint parts from the yoke.
-
If the front universal joint is being replaced, remove the bearing cups in the slip yoke in the same manner.
Inspect
-
The retaining ring grooves for dirt, corrosion, or pieces of the old ring.
-
The bearing cup bores for burrs or imperfections.
Clean
-
The retaining ring grooves.
-
Corrosion, dirt, rust, or pieces of the old retaining ring may prevent the bearing cups from being pressed into place or prevent the bearing
retainers from being properly seated.
Assemble
^
Remove the bearing cups from the universal joint and use your finger to coat the needle bearings in the bearing cup with a thin layer of chassis
grease.