Hombre XS Space Cab L4-2.2L CPC (1997)
5. Place J-23694 or equivalent seal installer over seal and tap seal into place. Seal is seated when flush with housing.
6. Pack remaining grease in seat assembly and on seal.
-
Make sure inner surfaces of seats are liberally lubricated.
7. Position ball support yoke and cross assembly in flange yoke, aligning reference marks made at disassembly.
8. Install bearing cups.
-
Check the ball seat assembly. The ball support yoke should snap over center to the right or left and up or down freely if constant velocity joint
is correctly assembled.