Hombre XS Space Cab L4-2.2L CPC (1997)
3.
Remove the three screws that secure the cover to the wiper motor and remove the cover (see figure 1).
4.
Inspect for sealant on the inside of the cover and then discard the cover and screws.
NOTE:
If sealant was found on the old cover, it will be necessary to remove any old sealant from the motor housing in step 6.
5.
Carefully remove the module (circuit board) from the wiper motor by lifting up on the end of the module electrical connector.
6.
If necessary, remove any old sealant from the wiper motor housing (see step 4).
NOTE:
When handling the new module in the next step, be careful not to damage or bend the electrical contacts on the bottom side of the module.
7.
Install the module into the wiper motor housing, making sure that the module is fully seated. When fully seated, the edges of the module circuit
board will be flush (even) with the motor housing along all sides.
8.
Carefully apply a bead of silicone sealant, P/N 8-12345-739-0 (or GE-162 sealant or equivalent) in the groove of the New Cover. Remove any
excess sealant that is outside of the groove (see figure 2).
NOTE:
