Hombre XS Space Cab 2WD L4-2.2L CPC (1999)
Compressor Sealing Washers
IMPORTANT: Use the correct washers. There should be a space of 1.2 mm (0.047 in) between the suction/discharge hose block and the compressor
rear head.
1. Clean all of the sealing surfaces with a lint-free rag in order to prevent dirt or foreign material from getting into the following sealing surface
components:
-
The washers
-
The hose block
-
The compressor ports
2. Install the sealing washer onto the pilots of the suction/discharge fitting.
Ensure that the washers are seated against the surface of the blockfitting.
3. Install the hose block to the compressor.
Ensure that the sealing washers are seated within the compressor's machined surfaces.
4. Hold the block in place and tighten the attachment bolt by hand.
Tighten
Tighten the bolt to 33 N.m (24 lb ft).
