Hombre XS Space Cab 2WD L4-2.2L CPC (1999)
Throttle Position Sensor: Description and Operation
Throttle Position Sensor
Throttle Position (TP) Sensor
The Throttle Position (TP) sensor (2) is a potentiometer connected to the throttle shaft on the throttle Body. The TP sensor electrical circuit consists of a
5 volt supply line and a ground line, both provided by the Powertrain Control Module (PCM), and a signal line to the PCM. By monitoring the voltage
on this signal line, the PCM can calculate throttle position angle in a percentage. As the throttle valve angle is changed (accelerator pedal moved), the
output of the TP sensor also changes. At a closed throttle position, the output of the TP sensor is low (approximately 0.6 volt). As the throttle valve
opens, the output increases so that, at wide open throttle, the output voltage should be near 5 volts.
The nonadjustable, throttle shaft-driven TP sensor is mounted on the throttle Body assembly opposite the throttle cam lever. The TP sensor senses the
throttle valve angle and relays the information to the Powertrain Control Module (PCM). Knowledge of throttle angle is needed by the PCM to properly
control the injector control signals (pulses).
The PCM can determine fuel delivery based on throttle valve angle (driver demand). A broken or loose TP sensor can cause intermittent bursts of fuel
from the injectors and an unstable idle, because the PCM thinks the throttle is moving. A high or low voltage problem in the TP sensor circuits should set
either a DTC P0122 or DTC P0123. The PCM also has the capability of setting a DTC P0105 if the sensor is reading out of range. Once a diagnostic
trouble code is set, the PCM will use a default value for the TP sensor, and some vehicle performance will return.
See TP Sensor Replacement for replacement of the TP sensor. The TP sensor is not adjustable.
