Hombre XS Space Cab 2WD L4-2.2L CPC (1999)
Ball Joint: Service and Repair
Lower
Lower Ball Joint Replacement (RWD)
Removal Procedure
Tools Required
-
J 23742 Ball Joint Separator
-
J 9519-D Ball Joint Remover and Installer Set
1. Raise and suitably support the vehicle with safety stands.
2. Remove the tire and wheel assembly.
Caution: Floor jack must remain under the lower control arm during removal and installation to retain the lower control arm in position. Failure
to do so could result in personal injury.
3. Place a floor jack under the control arm spring seat. Raise the jack in order to support the control arm.
Notice: Support the caliper with a piece of with to prevent damage to the brake line.
4. Remove the brake caliper.
5. Remove the cotter pin and the nut.
6. Break the ball joint loose from the steering knuckle using the J 23742.
Important: Place a wooden block between the frame and the upper control arm in order to block the knuckle assembly out of the way.