Hombre XS Space Cab 2WD V6-4.3L (1998)
Constant Velocity Joint: Service and Repair
Inner Joint and Seal Service
DISASSEMBLY PROCEDURE
-
Tools Required
-
J8059 Snap Ring Pliers
1. Remove the clamps from the seal with a pair of side cutters. Use a hand grinder to cut through the swage ring. Do not damage the tripot housing
(1).
2. Remove the tripot housing (1) and bushing (2) from the axle shaft (5).
3. Wipe the grease off of the tripot assembly roller bearings and housing. Thoroughly degrease the housing (1) and bushing (2). Use 320 grit 3M
cloth (or equivalent) to remove any evident corrosion in the transmission sealing surface.
4. Allow the housing (1) and bushing (2) to dry prior to assembly.
5. Slide the tripot seal (4) up the drive axle shaft (3), away from the spider assembly (1).
6. In order to remove the spider assembly (2), spread the spacer rings using J8059 (or equivalent).
Important: Handle the tripot spider assembly (1) with care. Tripot balls and needle rollers may separate from the spider trunnion if the tripot