i-290 2WD L4-2.9L (2008)
17. Install the lower sunroof frame to the sunroof module.
18. Install the screws into the proper locations of the lower sunroof frame assembly.
19. Tighten the screws in the lower sunroof frame using a cross-tightening sequence.
Tighten the screws to 3 N.m (27 lb in).
20. Place the sunroof window to the full open position. This will allow the window, motor and cables to be timed. Refer to Sunroof Track
Timing/Synchronization (See: Sunroof / Moonroof Track/Service and Repair/Procedures) .
21. Install the sunroof motor. Refer to Power Sunroof Motor Replacement (See: Sunroof / Moonroof Motor/Service and Repair) .
22. Close the sunroof window fully.
23. Verify proper operation of the sunroof.
24. Clean any excessive adhesive off the roof panel with a plastic-type scraper/razor blade and a 3M(TM) General Purpose Cleaner P/N 08984 or
equivalent.
25. Perform a water test to verify the leak has been fixed.
26. Install the sunroof front trim cover. Refer to Sunroof Front Trim Cover Replacement (See: Sunroof / Moonroof Interior Trim Panel/Service and
Repair) .