i-290 2WD L4-2.9L (2008)
14. Install the electrical connector.
15. Install the rear brake pipe to the retainer at the cowl.
16. Remove the paper and or shop towels from between the EBCM assembly and the inner fender.
17. Bleed the ABS brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair/Hydraulic Brake
System Bleeding (Manual))Hydraulic Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair/Hydraulic Brake System
Bleeding (Pressure)) .
18. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement and setup information.
