i-290 2WD L4-2.9L (2008)
assembly housing.
Important: Align the wheel speed sensor harness with the reference mark on the steering knuckle.
3. Install the wheel hub/bearing and brake rotor assembly to the steering knuckle with the wheel speed sensor harness positioned upward.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the wheel hub/bearing bolts (2).
Ensure the wheel speed sensor harness is positioned upward.
Tighten the bolts to 125 N.m (92 lb ft).
5. Install the wheel speed sensor harness bracket bolt (1).
Tighten the bolt to 20 N.m (14 lb ft).