i-290 2WD L4-2.9L (2008)
Valve Spring: Service and Repair
Valve Stem Oil Seal and Valve Spring Replacement
Tools Required
*
EN 46547 Flywheel Holding Tool
*
J 38820 Valve Stem Seal Installer
*
J 39313 Spark Plug Port Adapter
*
J 43059 Valve Retainer Remover/Installer
*
J-44228-A Valve Spring Compressor
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the service slot plug.
3. Install the EN 46547 (1) into the flywheel teeth.
4. Lower the vehicle.
5. Remove the camshafts. Refer to Camshaft Replacement (See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Camshaft
Replacement).
6. Remove the spark plugs. Refer to Spark Plug Replacement (See: Tune-up and Engine Performance Checks/Spark Plug/Service and Repair).