i-290 2WD L4-2.9L (2008)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Rear Oil Seal and Housing Replacement
Crankshaft Rear Oil Seal and Housing Replacement
Tools Required
*
J 8092 Driver Handle
*
J 44215 Rear Seal Installer
Removal Procedure
1. Remove the flywheel. Refer to Engine Flywheel Replacement (with Manual Transmission) (See: Transmission and Drivetrain/Flywheel/Service
and Repair)Engine Flywheel Replacement (with Automatic Transmission) (See: Transmission and Drivetrain/Flex Plate/Service and Repair).
2. Remove the 2 bolts securing the oil pan to the crankshaft rear oil seal housing.
3. Remove the crankshaft rear oil seal housing bolts.
4. Install 2 bolts into the threaded holes to act as jack screws and tighten evenly to release the crankshaft rear oil seal housing from the engine block
and oil pan.
5. Remove the crankshaft rear oil seal housing.
6. Remove the 2 bolts from the jack screw holes.