i-290 2WD L4-2.9L (2008)
1. Install new seal washers to the evaporator core fittings. Refer to Sealing Washer Replacement (See: Coupler HVAC/A/C Coupler O-ring/Service
and Repair/Sealing Washer Replacement) .
2. Install the TXV.
Notice: Refer to Fastener Notice.
3. Install the TXV bolts.
Tighten the bolts to 7 N.m (62 lb in).
4. Install new sealing washers on the evaporator tube and the compressor suction hose fittings. Refer to Sealing Washer Replacement (See: Coupler
HVAC/A/C Coupler O-ring/Service and Repair/Sealing Washer Replacement) .
5. Install the evaporator tube and the compressor suction hose to the TXV.
6. Install the TXV nut.
Tighten the nut to 20 N.m (15 lb ft).
7. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging (Non HP2) (See: Service and Repair/Refrigerant
Recovery and Recharging (Non HP2)) .
8. Leak test the fittings using the J 39400-A.