i-290 2WD L4-2.9L (2008)
3. Install the discharge hose (4) to the A/C compressor using new sealing washers. Refer to Sealing Washer Replacement (See: Heating and Air
Conditioning/Coupler HVAC/A/C Coupler O-ring/Service and Repair/Sealing Washer Replacement) .
4. Install the discharge hose mounting bolt (8) to the A/C compressor.
Tighten the bolt to 16 N.m (12 lb ft).
5. Install the generator. Refer to Generator Replacement (See: Starting and Charging/Charging System/Alternator/Service and Repair) .
6. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging (Non HP2) (See: Heating and Air Conditioning/Service
and Repair/Refrigerant Recovery and Recharging (Non HP2)) .
7. Leak test the fittings of the component using the J 39400-A.