i-290 2WD L4-2.9L (2008)
1. Lightly lubricate the sensor seal with clean engine oil.
2. Press the sensor fully into the fuel tank module.
3. Connect the chassis wiring harness electrical connector to the pressure sensor (1).
4. Install the left pickup box wheelhouse liner. Refer to Pickup Box Wheelhouse Liner Replacement (See: Body and Frame/Fender/Rear
Fender/Rear Fender Liner/Service and Repair) .
5. If the vehicle is a crew cab, install the fuel tank. Refer to Fuel Tank Replacement (See: Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Removal and Replacement) .
6. Lower the vehicle.