i-290 2WD L4-2.9L (2008)
Caution: Refer to Relieving Fuel Pressure Caution (See: Fuel Pressure/Service Precautions) .
7. Pull the connection apart.
8. Using a clean shop towel, wipe off the male pipe end.
9. Inspect both ends of the fitting for dirt and burrs.
Clean or replace the components as required.
Installation Procedure
Caution: Refer to Fuel Pipe Fitting Caution (See: Service Precautions/Technician Safety Information/Fuel Pipe Fitting Caution) .
1. Apply a few drops of clean engine oil to the male pipe end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.
3. Pull on both sides of the quick-connect fitting to make sure the connection is secure.
4. Inspect for leaks using the following procedure:
1. Turn the ignition ON, with the engine OFF for 2 seconds.
2. Turn the ignition OFF, for 10 seconds.
3. Turn the ignition ON, with the engine OFF for 2 seconds.
4. Turn the ignition OFF.
5. Inspect for leaks.