i-290 2WD L4-2.9L (2008)
1. Turn OFF the ignition.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove the seat belt pretensioner from the vehicle. Refer to Seat Belt Retractor Pretensioner Replacement - Front (Extended Cab) (See: Removal
and Replacement/Seat Belt Retractor Pretensioner Replacement - Front (Extended Cab))Seat Belt Retractor Pretensioner Replacement - Front
(Regular Cab) (See: Removal and Replacement/Seat Belt Retractor Pretensioner Replacement - Front (Regular Cab))Seat Belt Retractor
Pretensioner Replacement - Front (Crew Cab) (See: Removal and Replacement/Seat Belt Retractor Pretensioner Replacement - Front (Crew Cab))
.
5. When carrying a seat belt pretensioner to the deployment area, keep fingers clear of the seat belt webbing.
6. Clear a space on the ground about 1.85 m (6 ft) in diameter (a) for deployment of the seat belt pretensioner. If possible, use a paved, outdoor
location free of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
7. Make sure no loose or flammable objects are in the area.
8. Place the J 39401-B in the center of the cleared area.
9. Fill the fixture plastic reservoir with water or sand.
10. Mount the seat belt pretensioner (1) in the SIR deployment fixture (3) with the open end facing up using the following mounting method.
*
Adjust and secure the J 39401-B arms (4) to the deployment fixture.
*
To mount, use the proper size bolt (2) and nut (5) with washers in order to secure the seat belt pretensioner (1) to the deployment fixture
brackets.
*
Securely tighten all fasteners prior to deployment.