i-290 2WD L4-2.9L (2008)
![background image](/isuzu/i-290_2wd/l4-2.9l/Page-1658003.png)
Notice: Refer to Fastener Notice.
2. Install the bolt which retains the seat belt retractor/pretensioner assembly to the body.
Tighten the seat belt retractor/pretensioner bolt to 52.5 N.m (39 lb ft).
3. Connect the electrical connector to the retractor/pretensioner.
4. Install the seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.
Tighten the seat belt upper guide bolt to 52.5 N.m (39 lb ft).
5. Install the seat belt upper guide shoulder bolt trim cover.
6. Install the seat belt anchor bolt. Ensure that the seat belt webbing is not twisted.
Tighten the front seat belt anchor bolt to 52.5 N.m (39 lb ft).
7. Install the body rear corner trim panel. Refer to Body Side Rear Lower Trim Panel Replacement (Crew Cab) (See: Body and Frame/Interior
Moulding / Trim/Trim Panel/Service and Repair/Body Side Rear Lower Trim Panel Replacement (Crew Cab))Body Side Rear Lower Trim Panel
Replacement (Extended Cab) (See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Body Side Rear Lower Trim Panel
Replacement (Extended Cab))Body Side Rear Lower Trim Panel Replacement (Regular Cab) (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair/Body Side Rear Lower Trim Panel Replacement (Regular Cab)) .
8. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Air Bag(s) Arming and Disarming/Service and Repair) .
Seat Belt Retractor Pretensioner Replacement - Front (Regular Cab)
Seat Belt Retractor Pretensioner Replacement - Front (Regular Cab)
Removal Procedure
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Air Bag(s) Arming and Disarming/Service and Repair) .