i-290 2WD L4-2.9L (2008)
Evaporator Temperature Sensor / Switch: Service and Repair
Evaporator Temperature Sensor Replacement
Removal Procedure
1. Remove the radio. Refer to Radio Replacement (See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Radio/Stereo/Service and Repair/Radio Replacement) .
2. Remove the mounting screw from the evaporator temperature control module.
3. Disconnect the electrical connector from the control module.
4. Cut the evaporator temperature sensor wire near the control module.
Important:
*
Note the mounting position of the evaporative temperature sensor (a, b) and use these measurements upon installation.
*
If you are replacing only the control module, proceed to Step 4 of the Installation Procedure.
5. Remove the evaporator core. Refer to Air Conditioning Evaporator Core Replacement (See: Heating and Air Conditioning/Evaporator
Core/Service and Repair) .
6. Using needle nose pliers, carefully remove the evaporator temperature sensor from the evaporator core.
Installation Procedure