i-290 2WD L4-2.9L (2008)
Transmission Position Switch/Sensor: Adjustments
Park/Neutral Position and Backup Lamp Switch Adjustment
Important:
*
The following procedure is for vehicles that have not had the switch removed or replaced. If the switch has been removed or replaced,
refer to Park/Neutral Position and Backup Lamp Switch Replacement (See: Service and Repair) for the proper adjustment procedure.
*
Apply the parking brake.
*
The engine must start in the P (PARK) or N (NEUTRAL) positions only.
*
Check the switch for proper operation. If adjustment is required, proceed as follows:
1. Place the transmission range selector in the N (NEUTRAL) position.
2. With an assistant in the drivers seat, raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle
Lifting/Service and Repair) .
3. Loosen the park/neutral position switch mounting bolts.
4. With the vehicle in the N (NEUTRAL) position, rotate the switch while the assistant attempts to start the engine.
5. Following a successful start, turn the engine OFF.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
6. Tighten the bolts securing the park/neutral back up switch to the transmission.
Tighten the park/neutral back up switch bolts to 27 N.m (20 lb ft).
7. Lower the vehicle.
8. Check the switch for proper operation. The engine must start in the P (PARK) or N (NEUTRAL) positions only.
9. Replace the park/neutral position switch if proper operation can not be achieved. Refer to Park/Neutral Position and Backup Lamp Switch
Replacement (See: Service and Repair) .