i-290 2WD L4-2.9L (2008)
Shift Solenoid: Service and Repair
Control and Shift Solenoids Replacement
Removal Procedure
1. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement (See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/Automatic Transmission Fluid and Filter
Replacement) .
Important: Do not remove the valve body for the following procedures. Removal of the 1-2 accumulator is necessary only if servicing the
pressure control solenoid.
2. Remove the 1-2 accumulator if necessary. Refer to Accumulator Assembly, Spacer Plate, and Gaskets (See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Accumulator/Service and Repair) .
3. Disconnect the internal wiring harness electrical connectors from the following components:
*
Transmission fluid pressure switch (1)
*
1-2 shift control solenoid (2)
*
2-3 shift control solenoid (3)
*
Pressure control solenoid (4)
*
TCC PWM solenoid (5)
*
3-2 control solenoid (6)
4. Remove the pressure control solenoid retainer.
5. Remove the pressure control solenoid.