i-290 2WD L4-2.9L (2008)
2. Install the inner pinion bearing cup using the J 8608 (2) and the J 8092 (1).
3. Determine the selective shim thickness for the pinion. Refer to Pinion Depth Adjustment (8.0 Inch Axle) (See: Service and Repair/Overhaul/Rear
Drive Axle/Pinion Depth Adjustment (8.0 Inch Axle))Pinion Depth Adjustment (8.6 Inch Axle) (See: Service and Repair/Overhaul/Rear Drive
Axle/Pinion Depth Adjustment (8.6 Inch Axle)) .
4. Install the selective shim between the inner pinion bearing and the shoulder on the gear.
5. Install the inner pinion bearing using the J 24433.
Press the bearing on until the cone seats on the pinion shim.
6. Install a new collapsible spacer.
7. Lubricate the pinion bearings with axle lubricant. Use the proper fluid. Refer to Fluid and Lubricant Recommendations (See:
Maintenance/Specifications/Fluid Type Specifications) .
8. Install the pinion into the axle housing.
9. Install the outer pinion bearing onto the pinion.
10. Install a new pinion oil seal using the J 33782.
11. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the pinion yoke.