i-290 4WD L4-2.9L (2007)
Alignment: Procedures
Measuring Wheel Alignment
Measuring Wheel Alignment
Steering and vibration complaints are not always the result of improper alignment. One possible cause is wheel and tire imbalance. Another possibility is
tire lead due to worn or improperly manufactured tires. Lead/pull is defined as follows: At a constant highway speed on a typical straight road, lead/pull
is the amount of effort required at the steering wheel to maintain the vehicle's straight path. Lead is the vehicle deviation from a straight path on a level
road without pressure on the steering wheel. Refer to Radial Tire Lead/Pull Correction in order to determine if the vehicle has a tire lead problem.
Before performing any adjustment affecting wheel alignment, perform the following inspections and adjustments in order to ensure correct alignment
readings:
-
Inspect the tires for the proper inflation and irregular tire wear. Refer to Label - Vehicle Certification, Tire Place Card, Anti-Theft and Service
Parts ID and Tire Diagnosis - Irregular or Premature Wear.
-
Inspect the runout of the wheels and the tires. Refer to Tire and Wheel Runout Specifications.
-
Inspect the wheel bearings for backlash and excessive play. Refer to Wheel Bearings Diagnosis.
-
Inspect the ball joints and tie rod ends for looseness or wear.
-
Inspect the control arms and stabilizer shaft for looseness or wear.
-
Inspect the steering gear for looseness at the frame. Refer to Fastener Tightening Specifications.
-
Inspect the struts/shock absorbers for wear, leaks, and any noticeable noises. Refer to Struts or Shock Absorbers Testing - On Vehicle.
-
Inspect the vehicle trim height. Refer to Trim Height Inspection.
-
Inspect the steering wheel for excessive drag or poor return due to stiff or rusted linkage or suspension components.
-
Inspect the fuel level. The fuel tank should be full or the vehicle should have a compensating load added.
Give consideration to excess loads, such as tool boxes, sample cases, etc. If normally carried in the vehicle, these items should remain in the vehicle
during alignment adjustments. Give consideration also to the condition of the equipment being used for the alignment. Follow the equipment
manufacturer's instructions.
Satisfactory vehicle operation may occur over a wide range of alignment settings. However, if the setting exceeds the service allowable specifications,
correct the alignment to the service preferred specifications. Refer to Wheel Alignment Specifications.
Perform the following steps in order to measure the front and rear alignment angles:
1. Install the alignment equipment according to the manufacturer's instructions.
2. Jounce the front and the rear bumpers 3 times prior to checking the wheel alignment.
3. Measure the alignment angles and record the readings.
Important: When performing adjustments to vehicles requiring a 4-wheel alignment, set the rear wheel alignment angles first in order to
obtain proper front alignment angles.
4. Adjust alignment angles to vehicle specification, if necessary. Refer to Wheel Alignment Specifications.
Front Caster and Camber Adjustment
Front Caster and Camber Adjustment
Tools Required
J 45938 Alignment Socket
1. The caster and camber adjustments are made by rotating the offset cam bolt and the cam in the slotted frame bracket in order to reposition the
control arm.
Important: Before adjusting the caster and camber angles, jounce the front bumper three times to allow the vehicle to return to normal
height.
Measure and adjust the caster and the camber with the vehicle at curb height. The front suspension Z dimension is indicated in Trim
Heights. Refer to Trim Height Specifications.
For an accurate reading, do not push or pull on the tires during the alignment process.