i-350 L5-3.5L (2006)
13. Inspect the piston, piston rings, and connecting rod for damage. Refer to Piston, Connecting Rod, and Bearings Cleaning and Inspection.
Cylinder Bore Sleeve Installation
Note: Do not use assembly aids or lubricants on the cylinder bore sleeve or the cylinder bore block when installing a new cylinder bore sleeve, or engine
damage will occur. These items will not aid in the installation of the new cylinder bore sleeve.
Note: Do not chill or heat the cylinder bore sleeve or the cylinder block when removing or installing a new cylinder bore sleeve. Chilling or heating the
cylinder bore sleeve or the cylinder block will cause engine damage and will not aid the removal or installation of the new cylinder bore sleeve.
1. Place the NEW cylinder bore sleeve (117), PIN 88984239, onto the cylinder block.
2. Install fixture EN 45680-401/cylinder bore sleeve installer EN 45680-403 assembly (1), which is part of EN 45680-400,over the cylinder bore
sleeve (117) and onto the cylinder block. Do not apply downward pressure to the cylinder bore sleeve (117).
Important: Use 4 old cylinder head bolts for the attaching bolts.
3. Insert the 4 attachment bolts into the legs of the fixture EN 45680-401(1).
4. Tighten the 4 attachment bolts. Do not apply downward pressure to the cylinder bore sleeve (117).
Tighten
Tighten the 4 attachment bolts to 15 Nm (11 lb ft).