i-350 L5-3.5L (2006)
2. Notice: Refer to Fastener Notice in Service Precautions.
Screw the 3 pan head tapping screws into the multifunction switch/SIR coil assembly.
^
Tighten the screws (1) to 3 Nm (30 inch lbs.).
3. Route the wire harness assembly down the steering column.
4. Connect the multifunction switch/SIR coil assembly connector at the base of the column.
5. Install the wire harness straps to the wire harness assembly.
6. Remove the centering tab from the multifunction switch/SIR coil assembly.
7. Install the steering column trim covers.
8. Install the steering wheel to the steering column.
9. Enable the SIR system.