isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Air Bag Systems|Air Bag > < Electrical Test Equipment|Page 2704
Page 1
background image

Air Bag(s) Arming and Disarming: Service and Repair

    The Diagnostic Energy Reserve Module (DERM) which provides reserve energy to the deployment loop and diagnostic monitoring of all system
components, can maintain sufficient voltage to cause a deployment for up to 10 minutes after the ignition switch is turned off and the battery is
disconnected.
    To disarm airbag system, proceed as follows:

1.

Turn ignition switch to ``Off.''

2.

Remove SIR fuses C21, C22 and C23.

3.

Disconnect the orange 3-way connector at the base of the steering column.

    When all service work is completed, the following procedure is to be followed:

1.

Reconnect the orange 3-way connector at the base of steering column.

2.

Install SIR fuses C21, C22 and C23.

3.

Turn ignition switch to ``On'' position and ensure the ``INFLatable RESTraint'' lamp flashes 7 to 9 times and then goes out.

Air Bag Systems|Air Bag > < Electrical Test Equipment|Page 2704