Oasis LS L4-2253cc 2.3L SOHC VTEC MFI (1999)
15. Remove the flusher from the cooler line. Attach the drain hose to a container.
16. Install the transmission, and leave the drain hose attached to the cooler line.
17. Make sure the transmission is in [P] position.
Fill the transmission with ATF, and run the engine for 30 seconds or until approximately 0.95 liter (1.0 US qt.) is discharged.
18. Remove the drain hose, and reconnect the cooler return hose to the transmission.
19. Refill the transmission with ATF to the proper level.
Tool Maintenance
1. Empty and rinse the flusher after each use. Fill the flusher with water and pressurize it, then flush the discharge line to ensure that the unit is clean.
2. If discharge liquid does not foam, the orifice may be blocked.
3. To clean, disconnect the large coupling nut from the flusher.
4. Remove the in-line filter from the discharge side and clean it if necessary.
5. The fluid orifice is located behind the filter.
Clean it with the pick stored in the bottom of the tank handle, or blow it clean with air.
6. Reassemble all parts.