Pickup 2WD L4-2254cc 2.3L SOHC (4ZD1) MFI (1994)
PARTS INFORMATION
The parts listed below have been shipped automatically to each dealer. The quantity of parts shipped is dependent upon the number of affected vehicles
assigned to each dealer. Parts are to be obtained from American Isuzu Parts Distribution Network (AIPDN).
Part Number
Description
Quantity
8-97127-625-0
Differential
Pinion
Oil Seal
1
8-94376-262-0
Nut; Final,
Drive Pinion
1
2-90028-700-0
Label; Recall
Campaign
1
FLAT RATE MANUAL UPDATE INFORMATION
Use the revised labor operation as shown.
Service Procedure
IMPORTANT
The following service procedure is unique to this campaign and does not supersede the on-vehicle pinion oil seal replacement procedure described in
the 1994/95 Isuzu Pickup (TF)/Amigo (TC) Workshop Manual (Part No. 2-90994-022-0).
1.
Raise the vehicle on a hoist.
2.
Remove the filler plug.
3.
Remove the drain plug and drain the gear oil into a suitable container.
4.
Mark the propeller shaft and the pinion flange so that they can be reconnected in the same position (Figure 1).
5.
Remove the four pinion flange bolts, disconnect the propeller shaft, and support the propeller shaft out of the way.