Rodeo (4WD) L4-2559cc 2.6L SOHC (4ZE1) (1991)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
This component is non-serviceable and must be replaced as a unit, do not try to disassemble components.
1.
Raise and support vehicle.
2.
Disconnect harness connector.
3.
Disconnect brake lines from valve assembly.
4.
Remove isolation/dump valve retaining bolts, then valve assembly from vehicle.
5.
Reverse procedure to install, noting the following:
a. Torque isolation valve retaining bolts to 18 ft. lbs.
b. Torque brake line flare nuts to 12 ft. lbs.
c. Bleed brake system.