Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
11. Measure the plastigage width and determine the oil clearance. If the oil clearance exceeds the specified limit, replace the main bearings as a set
and/or replace the crankshaft (Fig. 6A-75).
12. Clean the plastigage from the bearings and the crankshaft. Remove the crankshaft and the bearings.
CRANKSHAFT BEARING SELECTION
-
When installing new crankshaft bearings or replacing bearings, refer to the selection table below.
-
Select and install the new crankshaft bearings, paying close attention to the cylinder body journal hole (1) diameter size mark and the
crankshaft journal (2) diameter size mark (Fig. 6A-77, Fig. 6A-79).