Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
/v6-3165cc_3.2l_sohc_(6vd1)/Page-260006.png)
-
Assemble the thrust washer to the No. 3 bearing journal. The oil grooves must face the crankshaft (Fig. 6A-84).
11. Main bearing cap
-
Apply engine oil to the threads and the seating faces of the bolts.
-
Install bearing caps in the order shown with the No.1 as the front most bearing cap (Fig. 6A-85).
-
Semi-tighten all of the bolts.
-
Finally, tighten all the bolts to specification in the order shown (Fig. 6A-86). Torque N.m (lb.ft) 39 (29)
-
After the final tightening, check to see that the crankshaft rotates smoothly.
10. Rear oil seal
-
Remove the oil from the cylinder block and the retainer mounting surface.
