Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
-
Install the snap ring with the inside indented portion facing out.
3. Shim(s)
2. Drive plate
-
Install the magnetic clutch armature to the compressor drive shaft together with the original shim(s).
-
Press the magnetic clutch armature by hand.
1. Drive plate bolt
-
Using drive plate holder (J-33939) to prevent the drive plate from rotating.
-
Tighten the bolt to the specified torque.
Torque N.m (lb.ft.) 15(11)
-
After tightening the bolt, check to be sure the pulley rotates smoothly.