Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
Throttle Position Sensor: Service and Repair
TP Sensor
REMOVE OR DISCONNECT
- Battery negative cable.
- Throttle Position (TP) sensor wiring connector
- TP sensor fixing screw
- TP sensor
INSTALL OR CONNECT
- TP sensor
- TP sensor fixing screw
- Tighten the fixing screw to the specified Torque.
Torque
2 Nm (18 lb-in)
- Use a "Scan tool" to check TP sensor output voltage with throttle closed, should be under 0.85 volts. If over 0.85 volts, check for binding throttle
shaft, or TP sensor lever. If all OK, replace TP sensor.
- TP sensor wiring connector