Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
Engine Control Module: Service and Repair
ECM
This component is non-serviceable and must be replaced as a unit, do not try to disassemble components.
REMOVAL
1.
Negative battery cable
2.
Lower left trim panel
3.
Disconnect ECM harness connector.
4.
Remove ECM bracket retaining bolts, then ECM.
NOTE: To prevent possible Electronic Discharge damage to the ECM, Do not touch the connector pins or soldered components on the circuit
board.
INSTALLATION
1.
ECM
2.
ECM electrical connectors (2)
3.
Lower left trim panel
4.
Negative battery cable