Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
Adapter: J-23075-12
2. Spring seat
3. Springs
4. Piston
INSPECTION AND REPAIR
Visual check
^
If any damage, deformation or local wear is found in a retaining ring, return spring, piston seals or spring seat, replace it.
Operation check
^
Shake piston and listen for check ball movement. Replace piston if check ball is missing or falls out.
REASSEMBLY
4. Piston (Fig. 7A-73)
^
The lip of the seals must point toward the front of the transmission. Lubricate the lip seal with transmission fluid.
^
Install piston assembly into the third clutch drum. Use installer to protect the outer seal during installation.
Third clutch piston installer: J-23084
3. Springs
2. Spring seat
1. Retaining ring
^
Place retaining ring onto spring seat.
^
Compress the piston springs, using the piston spring compressor.
CAUTION: Do not over-stress the springs and seat. Do not let the spring seat catch in the ring groove. This may cause damage to the spring seat.
^
Install spring seat retaining ring.