Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
OIL SEAL and/or BEARING
REMOVE
Tools required:
J-2619-01 Slide Hammer
J-22813-01 Axle Bearing Puller
1. Axle Shaft
2. Oil seal using a pry bar behind the steel case of the oil seal. Be careful not to damage the housing.
3. Bearing using J-2619-01 and J-22813-01. The tangs of the tool should engage the bearing outer race A.
INSTALLATION
Tools Required:
J-8092 Driver Handle
J-23765 Axle shaft Bearing Installer
J-23771 Axle Shaft Seal Installer
1. Bearing with J23765 and J-8092, until the tool bottoms against the housing shoulder. Lubricate the bearing with gear lubricant.
2. Oil seal using J-23771 until the oil seal is flush with the axle tube. Lubricate the seal lips with gear lubricant.
3. Axle shaft.