Rodeo (4WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
Wiper Control Module: Testing and Inspection
Fig. 60 Rear wiper controller
1.
Disconnect wiper controller electrical connector.
2.
Connect positive battery voltage to controller terminal No. 8 and negative to terminals No. 2 and 4, Fig. 60.
3.
Connect terminal No. 1 and ground, then approximately 12 volts should be indicated.
4.
Apply positive battery voltage to controller terminal No. 8 and negative to terminals No. 2, 6 and 7.
5.
Connect terminal No. 1 and ground, then approximately 12 volts should be indicated.
6.
If voltage is not as specified, replace controller.