Rodeo 2WD V6-3.2L (2003)
Wiper Switch: Service and Repair
Rear Wiper and Washer Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the dash side trim panel (1).
3. Remove the lower cover assembly (2).
-
Refer to Instrument Panel Assembly in Body Structure.
4. Remove the meter cluster assembly (4).
5. Remove the rear wiper & washer switch (5).
-
Disconnect the connector.
-
Push the lock from the back side of the meter cluster assembly.
Installation
To install, follow the removal steps in the reverse order, noting the following point:
1. Push the switch with your fingers until it locks securely.
