Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
3. Return spring
^
Adjust pedal free travel.
4. Brake pedal bracket assembly
^
Install the brake pedal bracket assembly.
^
Tighten the bolts and nuts to specified torque.
Specs
Torque Bolt 13 Nm (113 lb. in.)
Torque Nut 21 Nm (15 lb. ft.)
5. Bolts
^
Tighten the steering column fixing bolt (dash panel) to the specified torque.
Spec
Torque 19 Nm (14 lb. ft.)
^
Tighten the steering column fixing bolt (pedal bracket) to the specified torque.
Spec
Torque 17 Nm (13 lb. ft.)
6. Push rod pin
^
Apply grease to the entire circumference of the the Push rod pin.
7. Snap pin
8. Connector
^
Connect the anti-theft control module connector.
^
Connect the stop light switch connector.
9. Vent duct
10. Driver knee bolster
11. Meter cluster
12. Lower cluster
13. Instrument panel lower cover
^
Install the engine hood opening lever.
^
Connect the yellow 3 way SRS connector located under the steering column.
^
Connect the battery "-" (NEG) terminal cable.