Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
REMOVE OR DISCONNECT
1. EBCM
Solenoid Connector
2. Solenoid connector
CAUTION: Place a shop towel beneath the hydraulic modulator brake pipes to prevent brake fluid from contaminating motor pack or electrical
connectors.
3. Brake pipes
CAUTION: Do not allow brake fluid to get on painted surface, motor and electrical connectors.
4. Hydraulic unit fixing bolt
5. Hydraulic unit
^
Remove hydraulic unit from vehicle.
6. Harness connector
^
Disconnect motor pack harness connector.
7. Hydraulic unit bracket
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
Specs:
Hydraulic unit fixing bolt 25 Nm (18 lb. ft.)
Brake pipe (joint bolts) 12 Nm (9 lb. ft.)
Hydraulic unit bracket fixing 10 Nm (7 lb. ft.)
NOTE:
^
When installing solenoid connectors, be careful to install them in their correct positions as illustrated.
^
After installing, bleed air from brake system. See: Antilock Brakes / Traction Control Systems/Service and Repair/System Bleed
Overhaul