Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
2. Crankshaft main bearing caps [14]
^
Apply engine oil to the thread and seating surface of each bearing cap fixing bolt.
NOTE:
^
Do not apply engine oil to the bearing back faces.
^
Install bearing caps in the order of numbers, starting with cylinder block front side.
^
Tighten main bearing fixing bolts to the 39 Nm (29 ft. lbs.).
^
After tightening the bolts, make sure that the crankshaft rotates smoothly.
3. Connecting rod caps [13]
^
The cap number must be same as connecting rod number.
^
Apply engine oil to the thread and sealing surface of each nut.
^
Tighten nuts to 54 Nm (49 ft. lbs).
^
After tightening the nuts, make sure that the crankshaft rotates smoothly.
4. Rear oil seal retainers [12]
^
Remove oil on cylinder block and retainer fitting surface.
^
Apply sealant (TB1207 or equivalent) to retainer fitting surface, as shown.
^
Apply engine oil to oil seal lip, and align a positioning pin hole in the cylinder block with that in the retainer.
^
Tighten retainer fixing bolts to 18 Nm (13 ft. lbs.).
5. Flywheel [11]
^
Clean the tapped holes in the crankshaft.
^
Remove oil on crankshaft and flywheel fitting surface.
NOTE:
^
Do not reuse the bolts.
^
Do not apply oil or thread lock to the bolts.
^
Tighten bolts to 54 Nm (40 ft. lbs.).
6. Oil gallery [10]
^
Clean contact surfaces of oil gallery and main bearing.
^
Apply engine oil to oil gallery fixing bolts and tighten bolts to:
^
First tighten to 29 Nm (22 ft. lbs.)
^
Then tighten 55 - 65° more.