Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Throttle Position Sensor: Service and Repair
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the Throttle Position (TP) Sensor electrical connector.
3. Remove the bolt and the TP sensor from the throttle body.
CAUTION: Do not clean the TP sensor by soaking it in solvent. The sensor will be damaged as a result.
INSTALLATION
1. Install the TP sensor on the throttle body with the bolt.
2. Connect the TP electrical connector.
3. Install the negative battery cable.